Znajdź nas na portalach społecznościowych.

Dock leveller with swivelling and telescopic lip

Dock levellers CAMPISA are delivered with preassembled electro-hydraulic powering system underneath the leveller or with multifunctional Console function. It was designed to fit (after welding) standard loading bay or CAMPISA readymade systems (without welding): readymade station, readymade dock or readymade loading dock pavilion.
Structure of this dock leveller is compliant with standard EN 1398

Delivery: a truck trailer and accommodate 6-10 (depending on the type) leveller docks arranged in a stack 160mm x 6 (10). For transport purposes total length of the leveller with closed lip (swivelling lip) plus 150mm should be adopted.

Mounting edge profiles of readymade systems (only for readymade systems): patented system for mounting of edge profiles to the pavements which is resistant to nails sticking out of the pallets.

Head, which is the most strained part during loading is equipped with strong buckles which are firmly attached to mesh located below head and above head.

Technical specification:

Leveller: is covered with non-slip surface and equipped with machine weld supports.
Length of swivelling lip: standard 360mm fully extending over dock edge; optionally 430mm.
Length of telescopic lip: 500 or 1000mm.
Load bearing at concentrated load according to EN 1398: 6000kg (1000 at uniformly distributed load, but not on the ramp scope) optionally 9000kg (15000kg at uniformly distributed load – but not on ramp scope).
Finishing: ramp surface after degreasing and phosphatising is coated with two-component epoxy anticorrosion primer and two-component top coat of RAL 7005 and oven dried. Swivelling lip is painted with yellow-orange colour RAL 2000.
Power supply and control:

  • electro-hydraulic three-phase, 50Hz, 400V power supply system installed under ramp, with push buttons control
  • wall mount single phase, 50Hz, 230V electro-hydraulic console enabling safe, easy and economical maintenance, single command control or operation of several functions.

Using dock leveller with swivelling lip: issuing commands with one press button, lifting, lip opening at the highest position, lowering after button release. Return to resting position: the same press button lifts and closes the lip; release the button before the leveller reaches the highest position , the leveller returns to the resting position.

Using telescopic lip: press button for lifting leveller, the leveller stops upon releasing press button. A button should be pressed for extension of the lip; leveller is lowering after releasing of press button. For return to resting position and lifting the leveller above dock level release button, press button for closing lip, release button, leveller is lowering to the resting position.
Side adjusting: according to standard EN 1398 the dock leveller is adjusting to vehicle inclination up to 3% of its width.
Working inclination: Maximum inclination allowed by standard EU 1398 is 12,5%, however vehicles slide at this inclination. The largest inclination which transport means can conquer is 8% for forklifts and 4% for pallet jacks.

Additional equipment:

  • wind seals: main hinge equipped with this protection as standard. Side sealing available as optional equipment
  • Rubber bumpers: of SUPER type which constitute a part of readymade equipment – however bumpers for traditional docks for installation on plates by means of wall plugs need to be order.